Legos Ninjago Movie CMF Minifigure Display Frame

Display frame for ‘The Legos Ninjago Movie’ Collectable Minifigure Series (CMF) that came with 20 minifigures.

2 designs for the background in the print profile, one that has 4 colours with the eyes taking the shade of yellow as painted, and one with split eyes giving 5 colours, just have to glue the eyes from plate 9 in after printing separately!

Completely 3d printed, no other hardware needed!

Will hold all 20 minifigures as they are laid out on the check sheet and includes a print plate with various modified brick plates for accessories and deeper minifigures, ones with tails etc if you need, although space on this one is tight due to the 3 tall Garmadon characters!

----------------------------------------

Updates:

30/05/26 A new addition to the collection - a protective dust cover for these frames to keep your minifigures clean and dust free: https://makerworld.com/en/models/2864798-protective-dust-cover-for-minifigure-display-frame

See my other models for variations on this design holding different amount of minifigures: https://makerworld.com/en/collections/22219162-legos-minifigure-display-frames 

I have updated the frame design so it uses less support material and will print fine with normal PLA supports and with the settings in the profile.

----------------------------------------

Easy to assemble, print the background (choose different colours if you want!), print the frame and lower insert, print the pins and then print the minifigure bases.

Print the logo, there are settings included to make the fine lines work, this will gently twist fit into the front of the background so no glue needed.

The Background should slide in snugly to the frame first before adding the minifigure bases, slot in the lower piece and then push the 5 pin plate through - I have included different back plates so if you want to keep the paper checklist safe you can do this with one of the taller back plates - also included the stacker adapter so you can stack these frames when hung (only stack 3 or 4 frames just incase the pins break!).

Once this is assembled you can press into place the minifigure holders in the suitable spaces as shown in the image, recommend putting the bases on first and then adding the minifigures and their accessories afterwards.

There is an integrated screw hook on the back to hang it (remember to remove supports), or just free stand it.

If you do not have an AMS and want all 4 colours you can pause and change colours at layers 43 to green, then 50 for gold, then 57 for yellow.

The top 20 or so layers have been set to 0.08mm layer height to enable enough layers for the colour change, so avoid changing this.

The background has designed in reliefs to help prevent the corners curling, it only adds a bit of time and extra filament but I have found it to be very effective, but ensure there are no drafts and the print bed is clean.

Hope you like this, leave a comment and picture if you used colours and drop a boost to support me if you can!