Amo Sleeve buckle

It's convention time again!

I took a break from some other projects I am working on for con stuff.  I was helping a friend with her Amo cosplay and wanted to make a design accurate buckle for her sleeves.  I designed this to use with 1 inch elastic for the belt part, so any 1 inch fabric or elastic should be able to be used with this buckle print.  

**Please print vertically as it is oriented in the print profile and as shown in the photo.  If you print this laying on it's face it will be oriented in a way that will weaken the back where the slots for attachment are.  The orientation standing up puts the layer lines perpendicular to where elastic or fabric runs through and gives the print lots of strength.

I printed this in Silk PLA but it can be printed in PETG if desired.

Happy Printing!