Henry Stickmin Transdimensionalizer

“It's super easy to use and gives awesome results!” (Gadget Gabe 2012)

This is the Henry Stickmin Transdimensionalizer device seen in the Henry Stickmin Series. This is V.1. the antennas use support at the bottoms, since they are thin and tall. I can try to help with any commented problems faced. FREE TO SELL

Each of the parts have corresponding alignment divots. Every part is printed separately and uses PLA plastic. I used PLA light gray, dark gray, blue, and red.

Tips: The slider receiver will need a little cleanup, it has a tight fit, but still works. Also, I would strongly suggest you keep reading the description for best final results.

Gluing instructions: When gluing, glue the slider receiver on first, then the blue slider on at any point of the slider receiver you would like, but I would suggest the middle, because that is the neutral state. (third dimension) Next, set the body upright to glue in the antennas, which (luckily) fit almost perfectly. Make sure they are in correctly and are touching the bottom of the slanted divot as much as possible. after that has been checked, you can then glue the antennas in, make sure the body is upright the entire time antennas are drying so they don't sag! Last, glue the antenna ends on the ends of the antennas. 

Stay tuned for more Henry Stickmin Gadgets! (and a donut!)