Search models, users, collections, and posts
120mm Fan To 100mm Pipe 90 Degree Adaptor
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4.9 h
2 plates
Open in Bambu Studio
Boost
111
291
12
9
278
96
Released
Description
Design
This model has been designed to fit standard 120mm fans supplied by computer/chassis/rack fan manufacturers to feed into a 100mm flexible ventilation pipe with a clamp.
Printing
The two parts have been designed to be printed directly on the print bed with no supports. In the case of the part that attaches to the pipe the 100mm end should be on the print bed. PLA worked fine for me.
Assembly & Mounting
You will need two M4x8 screws and nuts and 4 M4 washers to connect the two parts. It will not be completely air tight unless you run some sealant around where the two parts connect.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (12)