Search models, users, collections, and posts
Big Red 3 ton SUV Trolley Jack Puck
IP Report
Print Profile(1)
0.28mm layer, 5 walls, 100% infill, supports
Designer
5.9 h
1 plate
Open in Bambu Studio
Boost
0
0
0
0
0
0
Released
Description
a jack pad/puck to protect the underside of the car when lifting it. it's designed to go around the pinch welds and avoid bending them.
it fits the “cup" on the jack 44mm wide and about 14mm deep and about 56mm on the outer diameter.
It's printed at 100% in TPU. (I haven't tested it yet, but it should work)
it was printed with supports, but you could try turning it off if you want. it kind of worked but was hard to remove.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)