Search models, users, collections, and posts
10/22 Ranger Plate w/ Locking Nut
Remixed by
IP Report
Print Profile(1)
0.12mm layer, 2 walls, 15% infill
Designer
1.5 h
1 plate
Open in Bambu Studio
Boost
0
3
0
0
3
2
Released
Description
This is a remix of the 10/22 Ranger Plate by Mikluck on Printables. I have modified it to accept a lock and bolt that connects it to the magazine rather than having to use glue or another adhesive. I used an M4x10 bolt and nut to hold the lock in place and it sits right into the arc in the magazine. I have seen other models take advantage of this arc in similar ways but I was unable to find a ranger plate version so I modified this to suit my needs.
Make sure to check out Mikluck on Printables and look at their version and other models as well.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)