Desktop Vehicle Charging Bay

Extended from a master below

It wasn't open source before because it was made with temporary parts and wasn't very good. I thought I'd revise it when I had time, but I kept forgetting. Now I'm releasing it; you can adjust it yourself if anything is not good, or leave a comment, and I will make changes when I have time.

Accessories:

Type-C digital display charging module *3

Type-C female connector *1

Self-resetting metal switch *3

2-pin terminal block pair (2mm pitch) *4

Lithium battery (any type) *3 You can do as the original master did, so there's no top cover. If using soft pack batteries, control the size within 31mm*17mm*12mm, multiple can be connected in parallel (because my batteries are disassembled, I haven't seen batteries of this size).

Magnet 8mm*1.85mm

2M screws *4, 1.6M screws *3 (optional)

502 super glue, hot melt adhesive

You can refer to the following for purchase

Here is the tutorial

Finally, just replace the battery connection point of the vehicle with a connector.

Most parts can be modified by yourself; it's not perfect.