OPPO Find X9 Ultra Case with MagSafe

This is a 3D printable case for the OPPO Find X9 Ultra.

Features magnetic ring support, and extra protection on the corners.

Instructions

The main body should be printed in TPU, I used some 64D TPU.

• I painted on a Fuzzy Skin modifier in Orca Slicer to give it more grip on the outside.
• May require supports for the button holes. 

Buttons work best in a normal plastic such as PLA.

• Use a thin piece of tape to secure them to the inside of the case.

The camera protector can be printed in anything, but TPU is best for protection.

• Requires supports, can be printed in either flat orientation.

Magnets and camera bump can be glued or taped in place.

Supports

I used a Sharpie marker on the support interface for clean surfaces, following the instructions here, as normal supports with TPU are hard to remove.

Magnets

I bought the magnets from AliExpress. Here are the measurements: (Listing says 0.2mm thick but the entire thing measures to around 1.2mm). I left the blue part attached, but you may need to remove it depending on the orientation of the magnets. (I bought some once that were the wrong way around)

Other

I plan on making another version of the camera bump that covers more of it leaving smaller holes for the lenses. If anyone wants I can upload a version without the magnets at all, or the STEP files if you have different magnets.

Also on Printables!