1:35 StuG III G 75/105mm barrel selectable, movable gun barrel and running gear

At this scale, I tried my best to retain the details of the original vehicle. I used a 0.4 nozzle; I haven't tried 0.2, but theoretically, the details would be better

Parts indicated by red arrows require glue for assembly, while parts indicated by blue do not

The filament used is PLA. I used black PLA for the tracks, rubber wheel rims, and on-board tools

Antenna holes are reserved; a piece of filament can be inserted as an antenna

There are two types of gun barrels: 75mmL/48 and 105mm howitzer. You can choose which one you prefer to print

There are two types of road wheels: one is a one-piece design for easy assembly, and the other is separately printed with black rubber edges, which offers better visual effect. You can choose whichever you prefer

Below are the assembly instructions

The inner and outer halves of the drive sprocket and idler wheel require glue for assembly, and it is recommended to use glue between the corresponding fixing pins and the vehicle body for stability, but do not apply too much, otherwise excess glue will stick the wheels as well

The road wheels, except for the black rims, do not require glue

The placement of on-board tools is not strictly limited

Position reference

The adhesive position of the additional armor hangers is for reference only. Since they are printed parts assembled together, there may be some errors. Please adjust as needed to prevent the armor plates from not hanging properly

Except for fixing the gun shield, the gun barrel does not require glue for other parts

The attachment points for the additional armor are hooks and do not require glue, but you can choose to apply glue for added stability

Completed view