Henry Stickmin Teleporter

This is the Henry Stickmin Teleporter device seen in the Henry Stickmin Series. This is V.1. Supports may be needed, but probably not. Feel free to comment any problems faced, and I will do my best to help. FREE TO SELL

Alignment divots are included to help line up parts. Each piece is printed separately, and uses PLA. The colors I used were PLA green, red, mustard yellow, (which can just be yellow) and gray. Every piece will have to be glued, and the antenna may need a bit of cleanup since it has a tight fit. 

WARNING: DO NOT SKIP THIS! Seriously, this is very important, if you run into the problem where your green buttons are in really tight fits and the spacing between each of the green buttons is uneven, it is because they are not put into the right spots. don't worry, that was purposeful so that the gadget's green buttons can look, well, like buttons. I'll admit I don't know the exact placement, so I suggest putting them in in different ways till you figure it out, don't worry, it is possible, I printed the same thing, and I (eventually) got it. The tightness is because of the arrangement of the top two smaller green buttons. To be sure that they are in right, they should: Slide in and out easily, have even spacing between each other, and mach their divots with the middle red button comfortably.

Tips for gluing: when gluing, first glue the antenna to the antenna tip, then set that aside. After, glue the big green button to the red button. Then glue the big green and red buttons to the inside floor, not inside walls, of the gray body. Next, glue both small green buttons to the red button and inside floor of gray body. Now, set the almost finished Teleporter to an upright position, with antenna alignment divot facing up. Last, glue the antenna in.

This is my second model of my Henry Stickmin Gadget Collection, and is still definitely not my last! I'm still working on the clickable buttons, but first I'm going to post all of my V.1s.