Search models, users, collections, and posts
fuyuhiko kuzuryu figure
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
24.9 h
2 plates
Open in Bambu Studio
Boost
2
4
0
0
1
1
Released
Description
I couldn't find a figure of Fuyuhiko Kuzuryu from Danganronpa 2. So I found a couple of images from the internet of an existing figure and added it into Meshy AI and created this. Split the head from the body and added a 5mm x 5mm peg connector for the joint. I did this because there is more than 4 colours for the AMS. Spent about 30 minutes using Bambu Studio to paint the different colours and created the logo on the tie. Set supports to auto tree and set Z-Top to .275. It took about 9 hours to print the body and 14 hours to print the head. I've used super glue to connect the two halves. Total height comes to about 18cm. It isn't perfect, but it works.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)