Mini Mushrooms (AMS and Single-Color versions)

Hello everyone! 👋 This is a fun Mushroom that I have had fun making in CAD software that I use. After a while of designing and printing I think I finally got the ratio's right of dots → mushroom.

1. Multi-Color and Single-Color versions

   These mushrooms are available to print with both AMS and Single-Color! I printed the Multi-Color Mushrooms on my P1S with the AMS 2, and while it did use quite a bit of filament, it paid off and I was able to print 6 different colored mushrooms!

   

2. 

3. Easily removeable supports (If you have a bed scraper)

   As shown below, using a bed scraper that I have, I was able to remove the supports, and here's how -------

   First, put your mushroom on it's side like I did in the picture 

   Second, set your bed scraper in between where the mushroom and supports meet

   Third, while slightly pressing down, gently wiggle your bed scraper back and forth in the mushroom/support connection area and try to separate them. If the mushroom doesn't disconnect from the support fully, keep your bed scraper in the area you detatched your mushroom/support from each other and slide your bed scraper through the groove all the way around the mushroom or until it disconnects.

    

   Please, if you have any tips for me of any kind, (such as different ways to remove the supports) feel free to tell me in the comments or in a chat.