Search models, users, collections, and posts
MacBook USB-C Coupler
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
20 min
1 plate
Open in Bambu Studio
Boost
1
9
0
0
4
3
Released
Description
There are already several similar models out there, but I needed a coupler that could accommodate two of my “slightly larger” USB-C cables.
I measured several of my cables and found that there is quite a lot of variation regarding the sizes… which is why the file includes two models. It’s best to print both—I’m keeping my fingers crossed that one of them will fit your cables (if in doubt, some tape or similar can help fill in the gaps ;)
No supports needed.
I use M2x12mm screws (10mm might work too - let me know in case it doesn't) and an M2 nut.
Recommended to print with PETG (because it's a little more flexible) – PLA might work too.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)