Battery Power Slider + Flip Fidget

Thank you for your support! If you like our family's designs - you can sell the physical prints through a paid Patreon membership: 

https://www.patreon.com/c/SpacedOutStudio

Let this fully cool after print (you can remove from the build plate) and rotate the hinges – NOT the pin – and then press the pin between your fingers to break the supports (don’t twist the pin – see image below). If you have filament and settings dialed in you can also gently twist the pin until you feel a little resistance (do not over twist), then twist the other way gently until it fully loosens. The hinges should move just fine. The more you play with it, the more it will loosen. PLA will work great. Some filaments will allow movement right after the print.  If you have issues, please contact me and happy to help. 

⚡Low Battery Mode <=> Fully Charged Chaos ⚡

Sometimes we’re fully charged… and sometimes we’re running on 1% 🔋

This battery-powered fidget gets it. One side is all green energy — fully charged and ready to go ⚡—while the other side is hanging on for dear life in full “low battery panic” mode. Flip it, slide it, twist it, spin it, and snap it your way between productive powerhouse and “please find a charger immediately.”

This little energy pack has more moves than your daily mood swings — flip, slide, twirl, rotate, twist, and slip your way through the day. It’s basically a physical representation of modern life… our devices (and let’s be honest, us) are either at 100% or completely drained. No in-between. Quick print in 3 colors.