Minecraft Chest - 15x15 - 100% Functional

Minecraft Chest - 15cm x 15cm

AMS required for the following parts:

The top and bottom parts of the chest where the top part is colored black to match the chest's design as closely as possible

If possible for supports, use PETG (which does not bond well with PLA and will facilitate support removal without leaving marks) as an interface base for the top and bottom parts of the chest

Required Material:

You will need 4 magnets of 6x2mm for the chest handle

Ideally super glue to bond the different parts

Assembly:

-Once everything is printed, you just need to assemble the bottom structure with the bottom part of the chest and do the same with the top structure and the top part. Use glue if the parts are too loose.

-Glue the chest handle to the top part, wait for it to dry, and insert the magnets into the bottom part of the handle and likewise into the chest. (If there is too much play, do not hesitate to use glue once more)

-Fit the top and bottom parts of the chest together and slide the rod into the hinge.

-Finally, glue the two hinge covers, making sure to glue them ONLY onto the rod, and ensure that the glue does not spread onto the fixed parts of the chest.

You can obviously use any colors you wish, I chose to use PLA Matte Black, PLA Matte White, and PLA Matte Terracotta, as well as Bambu PETG Basic for the support interface base.

If you like my model, feel free to Boost it and send a photo of your prints.

I am open to any modifications/improvements you might suggest, feel free to do so

Thank you very much!