ESP32-32E 3.5in Vertical Standing Case

Most cases I found just didn't fit my needs. So I started over and designed one that did. This case is meant to stand vertically as a display for print time left and cooling temperature. Plus, unlike other cases, there is a bezel to cover the edges of the display, which keeps it clean looking. 

To assemble the case and the back supports, you'll need (4) 3mm x 8mm Cap Head Hex screws for the face frame, and (4) 3mm x 8mm Button Head screws for the back supports. 

It was also designed to use a very thin 90 degree USB-C cable, readily found on Amazon or other shopping sites (see picture). 

The ESP32-32E used in this project is a Hosyond 3.5 in ESP32 Display.  Because I don't connect anything external to the display, there are no visible openings on the case. If you need them, ping me and I'll consider adding openings. 

You'll notice that there are some holes on the top edge of the supports - this is due to extra long screws I used initially. The model is update with shorter holes in the support.