The K.O. Bear

Here comes my last model for now:

The K.O. Bear 🐻🍺

As just seen, there are similar models from designer krack0 . I had not seen them before or deliberately copied them, but for safety, I wanted to mention this and ask you to check out his brilliant models before printing mine.

Actually, the bear pretty much shows how I currently feel here on MakerWorld.
I believe anyone a bit older (I was born in '73 😅) knows this feeling:
When the night was long again, you look in the mirror the next morning and think:
"Who... or what... are you exactly?"

That's exactly how my K.O. Bear looks after a night of partying — slightly wrecked, completely done for, and already in energy-saving mode internally. 😄

You can read why this is probably my last model here on MakerWorld after the description in my little statement.

This time, there is only an AMS and a OneColor version — and no... there will be no multi-part version either. 😅

The bear has a height of 100 mm, but can of course be scaled as desired.
Everything was printed with:

• Layer height: 0.16 mm
• Nozzle: 0.4 mm

When removing the support, small pliers are very helpful. However, if the print bed is clean and the printer has been properly calibrated, it works without problems.

If you like my work, I would be very happy about feedback, a like, or a boost. ❤️

Small personal statement

As written above, this will be my last model that I upload here on MakerWorld for a long time — or perhaps even forever.

The reason for this is unfortunately quite sad:
Recently, I have been receiving increasing threats again — against me and even against my family.

These "AI trolls" post negative comments, report my models, and then block me directly so that I cannot even react.

I can endure threats against myself.
But when messages like:

"Your family should die because you use AI and thus kill animals"
or because I use AI as support…

Just so you know, I have been volunteering for animal welfare for several years, so I will not tolerate such "stupid" claims.

…then the fun stops for me definitively.

I have never made a secret of the fact that, besides Nomad Sculpt, Adobe, Fusion360, and Split3r, I also use AI for support.

I am not a trained designer.
I do all of this in my free time, invest many hours, and make the models available for free so that others might also enjoy them a little.

But at some point, a limit is simply reached.

Therefore, in the future, I will probably only design and print for myself and my circle of friends.

To the majority of you, I still want to say a heartfelt thank you ❤️
For your support, your great feedback, and the many kind messages over the past years.

And to the "AI" trolls:
You can now find another victim so you don't get bored in your seemingly very boring lives.
Apparently, you really have nothing better to do