Pricking iron / chisel pull out board

This small multy purpose board is useful for pulling out pricking irons or chisels from leather after punching is done. The board helps avoid stretching leather or deforming the holes while you pull out the iron. 

It can also be used as a template to cut round corners of various radius, 5mm, 10mm, 15mm and 20mm. 

Finally, along the gap there's measurements for 2.7mm and 3mm spacing for holes. You can use this to check the placement of holes before you put them in. To see for example where your last hole will end up in the leather and if you need to make adjustments.