Round Robin Tracker

Round Robin Tracker

I have a regular group of guys I play pool with and we quite often start off a session by playing each other at Fast-8 in a round robin format (everybody plays everyone else once).

I was looking for a way to keep track of who needed to play who and what the results were and came up with these tracker boards – I made them for 4, 5 and 6 Players.

After a match has been played simply move the slider over the player number that won the match to keep track of wins / losses.

I printed these in PLA on a P1S printer with an AMS. 

This can be printed without an AMS by pausing at the filament changes. 

Round Robin Tracker filament change layer 44.

I did ‘cheat’ by using the ’0.08mm Extra Fine @BBL X1C’ presets – this worked ok for me I don’t know if it was really necessary. 

As far as the sliders go, there is a notch on each of the individual match-ups. 

Hook the top two feet of the slider over the top edge of the individual match-up then slide it along until you can press one of the bottom feet through the notch – keep some pressure on the slider and keep sliding it across until the remaining bottom foot drops into the notch.

I had previously created a mini leaderboard that allowed names to be tracked against numbers (https://makerworld.com/en/models/2735007-mini-leaderboard#profileId-3032008) so I decided to create a base board that allowed the leaderboard and the round robin tracker to be combined as shown below.