Glider Shad 3D Printable Jerkbait (No Supports)

Got it — here’s the clean English version, ready to paste straight into MakerWorld:

LURE LABS – Glider Shad V1 | Realistic 3D Printable Jerkbait (No Supports)

The Glider Shad is the first release from LURE LABS — a realistic 90mm shad-style jerkbait designed from the ground up for FDM printing. No supports, no fuss, just print and fish.

Tested on perch and trout in Dutch canals. It has a wide, lazy glide on the twitch and a tight wobble on a slow retrieve. Perfect for BFS setups.

FEATURES

• 90mm length, ∼11g in PETG (adjust weight with infill)
• Realistic scale texture, red eye, and orange-tail colorway
• Prints flat on its side — NO SUPPORTS NEEDED
• Three reinforced line-tie points for 6mm split rings
• Optional internal weight chambers for 2x 3mm steel balls
• Includes two versions: Stealth Silver & Orange-Tail

PRINT SETTINGS

• Printer: Bambu Lab X1C / P1S (works on any well-tuned FDM)
• Material: PETG or ASA recommended (PLA+ works for testing)
• Layer height: 0.12 mm
• Walls: 4
• Top/Bottom layers: 5
• Infill: 15% Gyroid (20-25% for slow-sink)
• Orientation: As provided, on its side
• Supports: Off
• Seam: Back or aligned to belly

HARDWARE NEEDED

• 3x split rings, 6mm
• 2x treble hooks, Size #6 (optional — run hookless for testing)
• Thin CA glue for sealing (recommended)

ASSEMBLY

1. Print and remove any light stringing.
2. Install split rings in nose, belly, and tail.
3. Add hooks if desired.
4. Optional: coat with thin CA or epoxy, wet-sand 800 grit for a waterproof finish.

ACTION TIPS

• Twitch-twitch-pause: 60cm side-to-side glide
• Slow steady: subtle shad wobble
• Best on 4-8lb fluorocarbon, BFS rod