Crivit Urban 3.0 X/Y - Handlebar Riser
Print Profile(1)
Description
Since I got my Crivit Urban 3.0X I found that the handlebars where a bit to low. I couldn't find any addons at the Crivit store, so I made my own.
By default the handlebar has a couple riser rings (see foto), but there was room for more. So, I measured the original risers and designed the new one to be 2.5cm higher. It does have a litle bit less room to hold on the tube, but I think it works fine. It feels very solid. It rises the handlebars just a little bit so it's a bit more comfortable.
It's not like OEM, so please use at your own risk.
It is very easy to mount. Just undo the top bolt and loosen the 2 side bolts of the handlebar. You can then take off the handlebar, remove the original risers and place the new riser. Then just bolt on the handlebar again. The small ridge should ‘lock’ inside the handlebar halves.
You do need a M6x60 or M6x70 bolt. Because the original one will be to short. I've used a M6x60 bolt.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (3)