Scoop Holder for ESN Creatine 250 g Jar

This scoop holder ring is designed for the ESN Ultrapure Creatine 250 g jar and was tested with the original scoop included with that container.

It helps keep the scoop accessible at the top instead of letting it disappear into the powder, making daily use a bit cleaner and more convenient.

The model is lightweight, simple, and made as a practical everyday accessory for this specific jar and scoop combination.

Approximate dimensions are 93.5 mm outer diameter, 89.0 mm inner ring diameter, 83.5 mm free inner opening, 23.6 mm scoop holder outer diameter, 20.8 mm scoop holder inner diameter, 6.6 mm overall height, and 5.8 mm inner section height.

The shown test print was made in PETG with a 0.4 mm nozzle and 0.20 mm layer height.

No supports and no brim are required.

Material usage is about 7.5 g or 2.5 m, and total print time is about 20 minutes on the shown setup.

For best results, print the model flat on the build plate in its standard orientation.

Because printers, materials, and tolerances can vary, please check the fit on your own container and scoop before regular use.

This is an unofficial accessory and is not affiliated with, sponsored by, or approved by ESN or The Quality Group.

ESN is mentioned only to describe compatibility with the tested jar and scoop.

Food-contact suitability depends on the filament, printer condition, print settings, and post-processing, so use is at your own discretion.