Ultimate Orbiting gear Fidget

This Orbiting Gear Fidget is made for anyone who finds gears and fidgets run and interesting. Using a combination of 4 different pieces (Large gear, small gear, and 2 connector pieces (male and female)) to create a fidget that uses a small gear orbiting around a larger gear to create a satisfying orbiting motion that you can spin around your finger by using the momentum of the small gear. This simple and compact design only uses 17.34 grams of filament, and 56 minutes to print! The only materials needed (besides filament) is a drop of glue to hold the connector pieces together. If you have any questions or recommendations, comment or message me :)

ASSEMBLY

1. Lay the female connector piece down on a surface, and lay the small gear into the circle shaft of the connector, and lay the larger gears indent into the other side of the connector piece

      2. Grab the male connector piece, add a dot of glue to the pin and carefully insert the pin into the slot of the female connector piece, while the other           end lines up into the indent in the large gear. As you insert the second connector piece, be careful not to touch glue onto the inside of the little                 gear, so that the connector piece and small gear won't fuse. (if they fuse it will ruin the motion)

      3. Wait for the glue to dry, and you're done!! (If you want a visual guide, see image 4 in the model profile)

Note: there are some small parts to this print so I recommend some plate glue so you won't have adhesion issues :) enjoy