Akaza HUEFORGE

Project: Akaza.hfp

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 230x230mm in size

You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.24mm and the Actual Thickness is 1.81154mm

    #000000 PLA BambuLab Basic Black  Transmission Distance: 0.6
    #00358e PLA BambuLab Basic Blue  Transmission Distance: 4
    #c00d1e PLA BambuLab Basic Red  Transmission Distance: 4
    #ffffff PLA BambuLab Basic Jade White  Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #7 (0.64mm) swap to Blue
    At layer #10 (0.88mm) swap to Red
    At layer #14 (1.2mm) swap to Jade White for the rest.

It might say you need supports but you don't
If you want to upscale, make sure to remember the z height, in this model it is 1.84, then rescale using the corners, then uncheck uniform scale,

then set the z height to 1.84 and thats it!

If you like my model, check out my account and see my other models!