Chibi Cartoon Layered Colors

Chibi character eating emoji pack printed with four colors of filament (red, yellow, blue, white), here using Bambu Lab official PLA Basic filament:

• 10100 Jade White
• 10200 Red
• 10400 Yellow
• 10601 Dark Blue

The models were generated by processing chibi images collected online using software such as Bilibili creator 大胖肥猫's open-source software Lumina-Layers and the open-source software ChromaPrint3D (online website https://chromaprint3d.com/, Github address Neroued/ChromaPrint3D).

If using other brands of filament, there will definitely be color differences, but it is important to remember not to use PLA Lite or various matte, poorly translucent filaments.

Note:

0.4mm nozzle, ensure good first layer adhesion and sufficient stickiness to avoid spaghetti failure. If the model warps locally, it is recommended to add a brim before printing, or further clean the build plate and apply glue to ensure sufficient adhesion, or slightly increase the printing temperature as appropriate.

The model size can be adjusted as needed, but be careful not to scale the Z-axis when resizing!!

If scaling, it is recommended to check the slicing results, as excessive reduction may result in details being too small and automatically ignored after slicing, making them unprintable.

In this model, repeated characters from previous versions (Remilia Squat Defense, Ice Elf) had skin tones added and some colors adjusted. However, Remi always has red artifacts after scaling down, and after seven or eight attempts, I still don't understand the principle, so I had to make it this large.