Frameless License Plate Mount
Print Profile(1)
Description
I made a custom license plate mount for an Audi RS5 grill, but the mounts fit almost EVERY car since it doesn't have to use the grill clamps to bolt on.
You need some hardware to bolt the mount plate on,
If you intend to print only PLATE 1 you only need the screws that are already on your licence plate frame
If you intend to use the clamps from PLATE 2 you need per pair;
2x M6 screw at least 12mm
2x M6 hex nuts
2x washers for M6 screw head
super glue
Glue the hex nuts with minimal glue into the clamp body's designated area; once dry, assemble the whole part like shown in the pictures, but don't tighten fully. Insert the part through the grill and then rotate the clamp 90 degrees so you can tighten the screw with a 10mm socket; be gentle but firm when tightening.
Licence plates can be installed by snapping them directly into the mount, but I suggest sliding them in sideways to avoid any damage.
Print from UV resistent materials
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including, but not limited to, publishing derivative works outside the Makerworld platform or hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money or collect fees. Subject to the above restrictions, derivative works may be published only within the Makerworld platform, and all such derivative works must be licensed under the same SDFL‑C license, without modification or additional terms. You may download the digital versions of this object, 3D print it, and display images, videos, or usage demonstrations of 3D printed versions of the object on personal social media platforms or Makerworld official channels, provided that no digital versions of the object are shared or distributed.
Comment & Rating (0)