WarGreymon can finally look up | FRS WarGreymon Brave Shield Extension Mod (copper pin insertable)

⚠️Note: Please print this modification at 50% speed, otherwise it's prone to spaghetti or warping

The original Brave Shield's peg is too short, the hair severely restricts movement, so the head can only stay down, and many poses cannot be achieved.

I made an extended modification to allow its head to look up, and it looks good from the front. The posture looks much better, and it can achieve some nice poses.

⬇️Left image shows the Bandai original, right image uses the extended modification⬇️

How to use

• It can be inserted directly and used, normal handling is fine
• There's a negative part inside for inserting a copper pin, adjust according to your pin size, mine is 1mm
• Not inserting a copper pin is also fine, the strength is sufficient, just don't handle it roughly

Precautions

• This modification is not particularly aesthetic from the side; it's a functional part, print as needed
• If there's a size deviation, you might need to sand or trim it, or adjust the contour compensation on the slicer page
• I've only tested it on my painted parts, there might be slight tolerances
• Because the rear part is extended, the center of gravity might shift backward, so be careful when posing