Micro Mini Kickboard Scooter Wall Mount

A simple wall mount for storing a Mini Micro Kickboard Scooter sideways against the wall. The mount holds the scooter by the handlebar, keeping it off the floor and out of the way while still making it easy for a kid to grab and put away.

I designed this because our scooter was always ending up in the entryway, hallway, or garage floor. This mount gives it a dedicated spot and keeps the footprint small by holding the scooter sideways against the wall.

Mounting

The modeled screw hole is 5mm diameter and recessed.  Either edit the model to make a larger hole or scale it up.  Use appropriate screws and wall anchors for your wall type. For best strength, mount into a stud if possible, especially if it will be used frequently by kids.  

Printing Notes

PLA is probably fine but if you can, print in a strong material like PETG, PLA+, or ABS especially if the mount will be in a garage or other warm area. 

Recommended settings:

• 3+ walls/perimeters
• 15-30% Infill
• Orient with the wall side flat on the bed
• Supports not required