Fiat 500e Foot Rest Protector – No Supports Needed

Protect your car’s interior with this purpose-built Fiat 500e Foot Rest Protector, designed specifically to prevent wear and tear on the original carpet in the driver foot rest area. Instead of dealing with worn or damaged flooring over time, this print acts as a durable protective layer where your foot naturally rests.

The model is fully pre-supported, allowing you to print it directly without adding any supports. This keeps the process simple, clean, and beginner-friendly.
 

Car interiors can get extremely hot, especially during summer. For this reason, material choice is important. It is strongly recommended to print using ASA, ABS, or at least PETG for proper heat resistance. PLA is not recommended, as it may soften or deform in high temperatures inside a closed vehicle.

Installation is quick and flexible:

• Attach Velcro to the back for a removable solution, or
• Use double-sided tape for a more secure, permanent hold

This model focuses purely on functionality and protection, helping extend the life of your Fiat 500’s interior without any permanent modifications.

Key Features:

• ✅ Designed to prevent carpet wear
• ✅ No supports required (pre-supported model). Just break the supports after print.
• ✅ Simple and clean print
• ✅ Heat-resistant material compatibility
• ✅ Easy installation (Velcro or tape)
• ✅ Non-permanent solution
   

Recommended Print Settings:

• Material: ASA / ABS / PETG
• Supports: Not required
• Infill: 15–20% for durability
• Layer Height: 0.24 mm recommended