ESP-02S TYWE2S Simple programming rig
Print Profile(1)
Description
Simple adapter for programming esp02s module. PCB gerber files are included in the .zip file. The big piece is a jig for aligning the pogo pins for soldering. It was a little difficult getting the soldered module out without bending them so you may want to break it to release (it's only needed once) or redesign for reuse. Solder the POGO pins before the header connector. Once assembled, it's simply a matter of placing the module on the POGO pins, squeezing then sliding the clip part on.
POGO pins I used: Dia 0.68mm Length 16mm
Pinout:
1 GND
2 I4
3 TX
4 I2
5 RX
6 -
7 VCC
8 GPIO0
IMPORTANT: Makerworld doesn't like .gbr files so you'll have to open the .zip and remove the .txt from each of the files before sending to fab.
Documentation (1)
License
You may create derivative works based on this object, provided that all such derivative works are published exclusively on the MakerWorld platform and include proper attribution to the original creator. You may not share, upload, host, distribute, or publish this object—or any derivative work of this object—on any other digital platform, marketplace, or distribution channel. Commercial use of this object and any derivative works is strictly prohibited. This includes, but is not limited to, selling, renting, sublicensing, or using the object in any context in which you receive monetary compensation or other financial benefits.
Comment & Rating (0)