Skull Bracelet (or Anklet)

This is a skull bracelet (or you can wear it as an anklet). It's a wearable, printable, bracelet that you snap together. It has 12 of the same pieces on one build plate, enough for you to put together and then connect the ends around an average to smaller sized wrist (if wearing as an anklet you will usually need more links). It's tough when put together, so this may cause it to be a little more difficult to take off, but pulling on one of the skulls so that the snaps come off the same way they go together is kind of the method to get it off.

• Made as links for you to print your desired amount and connect around your wrist or ankle.
• Prints okay in PLA, but would maybe be best in PETG or another strong filament. It looks good in white, black, or maybe another color; or alternating colors by link.
• There are 12 links on the build plate in the profile, enough to fit around an average wrist with a little room, but not fall off. If wearing as an anklet you will usually need more links.
• The links are within 1mm of the smallest they can get in the slicer without errors forming in the thin parts of the print. That size is 25mm in length for the long axis if the part is laying on the flat side. If you want to change the size of the links, you'll have to size them up.

buymeacoffee.com/vlspider/extras