Peugeot Speedfight drum brake AC cover
Print Profile(1)
Description
This is a self-designed wheel hub cover / rim cap for the rear axle of a Peugeot Speedfight scooter (suitable for models with AC / air cooling and rear drum brake).
Since the original covers have often faded, scratched, or simply gone missing over the years, I designed this replacement part. It protects the rear wheel hub from dirt and moisture and gives the scooter a clean, well-maintained original look again.
Features & Advantages
- 100% Custom Build: Perfectly adapted to the dimensions of the Speedfight rear wheel hub (drum brake).
- Clean Look: Covers the unsightly nut and axle of the rear wheel.
- Easy Print: Optimized for 3D printing without complicated overhangs.
Print Recommendations (Print Settings)
Since the component on the scooter is directly exposed to weather, UV radiation, and also the heat of the brake/hub, I recommend the following settings:
- Material: PETG, ASA or ABS (PLA is not weather-resistant and can deform in summer heat or brake warmth).
- Infill: 20% to 30% (Grid or Gyroid for good stability).
- Walls: At least 3 or 4 for a robust structure.
- Support: Depending on the orientation of your printing plate, minimal support may be necessary (you can see this in the slicer).
🇬🇧 English (For international reach on MakerWorld)
Description
This is a custom-designed rear wheel hub cover / rim cap for the Peugeot Speedfight scooter (suitable for models with AC / Air Cooled engines and rear drum brakes).
Since the original covers often fade, get scratched, or get lost over the years, I designed this replacement part. It protects the rear hub from dirt and moisture while giving your scooter a clean, factory-fresh look.
Features
- 100% Custom Design: Perfectly shaped to fit the dimensions of the Speedfight rear hub with a drum brake.
- Clean Look: Sleekly covers the rear axle and nut.
- Easy to Print: Optimized for 3D printing with minimal overhangs.
Print Settings
Since this part is exposed to weather, UV light, and heat from the brakes/hub, I highly recommend the following settings:
- Material: PETG, ASA, or ABS (Avoid PLA, as it can deform due to summer heat or brake warmth).
- Infill: 20% to 30% (Grid or Gyroid).
- Wall Loops: At least 3 or 4 for strength.
- Supports: Depending on your print orientation, minimal supports might be needed.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)