Out of the Frame – Carnage Outbreak

Out of the Frame – Carnage Outbreak

Chaotic Carnage violently erupting from his ornate frame in the Out of the Frame collection. Multiple symbiote tendrils wildly spreading in all directions while his monstrous upper body lunges forward with jaws wide and a thick tongue lashing out... pure symbiote madness breaking through reality. Integrated keyhole hanger on the back for easy wall mounting.

Print profiles

I sculpted all the thin tendrils thick enough so they won’t break easily, but there are still plenty of supports. Remove them carefully, don’t just yank them off. Instead, cut between the branches and use thin nose pliers if possible. One area failed during my first test print, so I painted more supports and tweaked the settings to make the print more reliable. I also applied filament overrides to reduce the chances of the nozzle knocking over supports, so I recommend using them.

100mm

• Layer height: 0.12 mm
• Walls: 2
• Infill: 10% Gyroid (infill combination enabled)
• Supports: Tree (auto) and painted, support wall loops 2, initial layer expansion 5mm
• Fuzzy skin (on variant): point distance 0.2 mm, thickness 0.1 mm

Plates

1. 100mm
2. 100mm fuzzy skin

150mm

• Layer height: 0.16 mm
• Walls: 2
• Infill: 5% Gyroid (infill combination enabled)
• Supports: Tree (auto) and painted, support wall loops 2, initial layer expansion 10mm
• Fuzzy skin (on variant): point distance 0.2 mm, thickness 0.1 mm

Plates

1. 150mm
2. 150mm fuzzy skin

Before the madness… there was the rage. From the same symbiote bloodline that gave birth to this chaos, came the original… the one who first broke through. Venom Breach! The shadow that started it all. Grab it here 👇

Key Printing Tips:

• Disable “Strength → Detect Thin Wall” → gives smoother, cleaner surfaces on detailed parts.
• Always check the slicing preview in Bambu Studio before starting the print.
• Support removal trick: Cut supports into small chunks first, then gently loosen → they usually pop off cleanly without damage.
• Some plates use lots of supports, if so → for reliable prints use these filament settings:
  • Filament Overrides
    • Z Hop When Retract: 0.6 mm
    • Z Hop Type: Spiral
    • Travel Distance Threshold: 1 mm
    • ✅ Enable Retract When Changing Layer
  • Also, disable these settings in Bambu Studio if Variable Layer height is used:
    • Supports
      • ❌ Disable Independent Support Layer Height
    • Others
      • ❌ Disable Reduce Infill Retraction
    • I’ve found that a 0.15 mm top Z distance works best when printing with variable layer height.

Happy printing! Can't wait to see photos of your prints! If you're scaling, experimenting or encounter any issues, let me know → your input helps the next iteration. Please share your feedback for any rating below ⭐⭐⭐⭐⭐ so we can work on improving, thank you!