Search models, users, collections, and posts
LMNT Packet Dispenser
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill, normal supports
Designer
3 h
1 plate
Open in Bambu Studio
Boost
17
70
1
0
28
30
Released
Description
LMNT Packet Dispenser
A clean, functional dispenser that comfortably holds 15 LMNT electrolyte packets — and a few extra if you press them in tightly.
Designed for LMNT packet dimensions:
- Length: 103mm
- Width: 38mm
- Height: 13mm
Packet height was measured at the max thickness, when all the powder is bunched up in one spot. The dispenser is sized for 15 packets at that worst-case height, but packets tend to settle flatter in practice, so you can usually squeeze in a few more.
Print notes:
- Prints with normal supports for the window and dispensing opening
- Supports come off cleanly, but a deburring tool is recommended for cleaning up the support remnants on the bottom of the opening
- No exotic settings required — standard PLA/PETG should work fine
Check out my other nutrition dispensers:
- Maurten Gel Dispenser — fits 12 gels
- Tailwind Rapid Hydration Packet Dispenser — fits 24 packets
Enjoy, and stay hydrated! ⚡
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (1)