Search models, users, collections, and posts
CC3D PETG clear profile
IP Report
Print Profile(1)
0.28mm layer, 1 walls, 5% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
9
21
0
1
19
10
Released
Description
I bought a spool of CC3D's PETG. I initially printed using a generic profile, but the results weren't very good.
This profile is specifically designed to maximize transparency. Strength and speed are not considered.
When I bought it, it absorbed moisture terribly, and even at 50℃, which is lower than the typical drying temperature for PETG (70℃), a lot of water droplets formed in the dryer. Drying is essential. I repeat: Drying is essential. I said it twice because it's important.
By the way, the board next to Benchy is a transparency sample.
Boost Me (for free)
Thank you! Have a nice day.
Looking for FPVskydive players whose usernames start with men5 or men2.
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (0)