Rain Gutter All in One Set: Gutter + 40mm Pipes

This is an all-in-one set of Rain Gutters that includes gutter parts, a 40 mm pipe adaptor to the gutter with a hole part and 40 mm printable pipes.

• Do you want to print a complete rain gutter set for your garden house or greenhouse with your great 3D printer?
• This model expands the original model of Rain gutter by BENOengineering and Rain gutter extended set by Noisy Boysie, who created all gutter parts (long from 111mm to 234 mm) that can easily be connected, including a mirrored version, gutter with down pipe hole, end caps and 90-degree corners.
• However, this complex project was missing a 40 mm pipe connector that I created (Ondrej Dvoulety), and pipes that can be connected to take the rainwater down to a barrel/tank/connector and make use of it for your gardening needs. 
• Therefore, I expanded this model by adding 40 mm pipes that can be fully printed with the gutter. 
• The 40mm pipe plate includes short and long straight pipes (180 mm and 338 mm), 90-degree corner pipes, obtuse angle pipes and pipe cross-roads (if needed),
• PETG, ABS or ASA is recommended for printing to ensure outdoor usage.
• If you experience issues with the fitting of pipes/adaptor, you can increase or decrease the size by a decimal of 0.1, but in my experience, as the model is now, it is tight enough, sometimes even a bit harder to put on, but it is water, so better a tight fit than sorry afterwards.
• Rain gutter parts fit together very well, but it is still wise to use superglue to connect them. Also, the End Caps need to be glued based on my experience.