Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
1.5 h
1 plate
Open in Bambu Studio
Boost
0
4
0
0
1
1
Released
Description
Content has been automatically translated.
There was only a belt version of the Nitecore quick-draw holster on the site, no MOLLE version, so I put together a MOLLE quick-draw holster.
However, if a standard MOLLE four-way module is used, the 2.5 mm shoulder strap is very short, turning it into a side mount.
The user experience is still very good.
Supports provided by the P1S were used, but it has been optimized into a split MOLLE, requiring only two supports, and it's fine without supports from other materials.
The MOLLE is used after being glued and cured, and its strength can withstand repeated loading and unloading.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)