XTOOL F2 ULTRA UV PRE FILTER
Print Profile(1)
Description
this is a pre filter for the xtool f2 ultra. uses 2mm x 5mm magnets same as factory. i use a shop vac foam wet filter for the filter and cut to fit. works great to save cleaning the fan as often. the f2 ultra where the magets touch is polarity sensitive so make sure you install magnet with the right polarity or it will not go in it will push it away. i use an oring pick with magnet on the end when you put up to the side plate it should push you away. that is the side of magnet you want facing towards the print to push in the holes.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (6)