XGunner Light Gun Recoil Buffer

I use the XGUNNER Light Gun, however the recoil is a little too excessive for me. After about 2 minutes of continuous firing, it's a little obnoxious. All was printed in TPU, as rubber would be quieter than plastic, but, it may still work to reduce the impact with PLA/PETG, so it wouldn't hurt to try, if thats all you have.

I included two main mods that help lower the noise, without stopping it or turning off the recoil function.

There is the main buffer, sits between the slide. I use the 7mm thickness, but included a 4mm if you prefer a little more noise and recoil. 
There are two different versions, a whole piece, which, from my testing, sits loosely, without falling off, but is just…. there existing. 
And a split version, which if you decided you like it, you can glue it to the light gun, but allows you to still open the device later for future repairs/mods etc.…

I also included O-Rings for the solenoid inside the device. First I am not responsible for any damages done to your device. It involves opening the device, disconnecting a couple wires, removing the board and taking the solenoid partly out. You would then remove the nut, slide the metal inner out, put one O-ring on, put it back in, put the other o-ring on the other side on, then put the nut back. It seems to help a lot with the metal on metal noise, but there are risks… I did pull apart two wires, which i just took my soldering iron and used what was already there to quickly reattach it. and trying to put the buttons back, while closing it back was frustrating, but found my tips. If you want more instructions, or advice and tips, just ask me. But I highly recommend trying the buffers first to see if you're then satisfied. There are 3 different size O-rings, I currently use the smallest, but haven't tested the bigger one. 

I don't assume many or any people would be interested in this, but, it's already made, and if it even helps one other person then great!