Parallel guide like Festool PA-TS55 >TS55/TSC55
Print Profile(1)
Bill of Materials
- M6 nut (regular, heigth approx 5mm) x 4:
- M6 hex head screw L=20 mm x 4: M6x20mm hex head
- Metal rods d=8mm, L=250mm or 300mm x 2:
Description
Parallel guide, replaces Festool PA-TS55, suitable for the Festool TS 55 FEBQ / TSC 55 as well as identically constructed saws with the corresponding rod spacing.
Enables precise parallel cuts without a guide rail from a width of approx. 2.4mm (thinnest cut, tested, see pictures). This was achieved through the special design of the rear screw (cost several prototype iterations… 😂)
In addition to the printed parts, the following are also required:
- 2x metal rods, diameter 8mm; length as needed, recommended 250mm or 300mm)
- 4x M6x20mm hex head screws with nuts
The holder for clamping the rods is already present on the saw - the M6 hex head screw can be pressed in from below.
Boost Me (for free)
...you want to put a smile on someone's face?
...then click here!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including, but not limited to, publishing derivative works outside the Makerworld platform or hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money or collect fees. Subject to the above restrictions, derivative works may be published only within the Makerworld platform, and all such derivative works must be licensed under the same SDFL‑C license, without modification or additional terms. You may download the digital versions of this object, 3D print it, and display images, videos, or usage demonstrations of 3D printed versions of the object on personal social media platforms or Makerworld official channels, provided that no digital versions of the object are shared or distributed.
Comment & Rating (0)