Search models, users, collections, and posts
Hartmann WPC End Profile
Remixed by
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
1.8 h
3 plates
Open in Bambu Studio
Boost
5
12
0
0
15
5
Released
Description
Content has been automatically translated.
End trim for Hartmann WPC decking boards, to prevent anything from getting in
I have revised the original model, so that it fits the WPC decking boards purchased at Baywa
Baywa sells Hartmann boards.
The changes concern the orientation and size of the model. The groove in the board is 5mm wide and approximately 7mm deep.
I have made 3 parts,
One PLA or PETG
One PLA/PETG + TPU
One PLA/PETG + TPU, without the outer lugs. It holds just as well
A hammer is recommended for assembly, it is a very precise fit
The PLA/TPU model is easier to insert
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)