Medieval Greaves Leg Armor

Medieval Greaves Leg armor, 

working on the rest of the knight light armor the Greaves, keeping you light and swift with enough coverage to keep you fighting. simple in design just like the bracers and the rest of the armor they are holding on till your last fight. easy to print just like the rest so you can get to the battlefield in no time.

• the measurements are 254mm long, 115mm wide by the calf and 89mm to the lower half. the middle part is 115mm wide and 51-64mm Hight from middle to end. the last arch cover is 101mm wide and 64mm high. 
• **** scale to your liking if needed if your upper calves and ankle areas are bigger****
• I added leather straps to mine like the bracers but add whatever is comfortable to you. I used E6000 glue to glue the leather straps to the shin guards
• then elastic band for the ankle and foot arch parts to have easier movement while the foot moves but holds tight to the areas.
• I would use paracord to loop through the holes and tie them all together so the stay together. Follow the pictures to see how it was done. loop through the front and through the holes and tie them together. slight play between but tight together for a tight look like in the photos.
• **** two versions available Damaged and Clean so you can pick either one****
• I had to flip the shin guard's upside down to fit inside the smaller printers but should print fine.
• the shin guards and ankle guards have and L and R on the inside of them to put them together and arrows should be up and the arch guard can go to any foot.
• *****ADDED A1MINI versions of both Clean and Damaged, Cut the shin parts in half you will need to glue or weld together ******