INSTA360 GO 3 Motorbike Helmet POV Mount

Insta360 GO 3 side POV mount designed for motorcycle helmets.

The mount is placed inside the helmet, near the visor area, and slides into the side padding. This allows the camera to be positioned close to the rider’s point of view without using external adhesive mounts or bulky accessories on the outside of the helmet.

Choose the model that best suits your helmet for an easy and stable installation.

Refer to the images above for the model dimensions.

The camera is held magnetically, without the need to pause the print to insert the magnets, making it quick and easy to attach or remove the camera when needed.

Please check the magnet dimensions shown in the reference image for correct installation.

The magnets should be installed using glue. Before gluing them in place, make sure to carefully check the polarity of both magnets to ensure proper alignment and magnetic attachment.

Exploded view showing the full assembly of the model.

The design is intended to be compact, practical, and easy to install, while keeping the setup clean and minimal.

Please feel free to leave feedback. Suggestions and requests for additional versions are always welcome and will help me expand compatibility with more helmet shapes and models.

Recommendations:

• Use PETG, ABS, PA6, or another strong and heat-resistant material. Fiber-reinforced materials are recommended for better structural strength.
• Avoid using PLA, as it can deform with heat and may degrade under UV exposure.
• Required magnets: 2x neodymium magnets, 15 x 3 mm.
• Check the model dimensions before printing.
• Check magnet polarity before gluing them in place.
• Be careful when using the side POV mount. Foreign objects inside the helmet can cause serious injury in the event of a crash or accident.