Search models, users, collections, and posts
FOLLOWER (ASA) GLOCK Magazine G17, G19, PCCs...
IP Report
Print Profile(1)
FOLLOWER GLOCK Magazine ASA 0.12mm layer 6 walls, 65% infill
Designer
41 min
1 plate
Open in Bambu Studio
Boost
17
37
2
0
30
14
Released
Description
Simple Glock follower, printed in ASA with support structures for a clean finish.
It was important to me that the sliding surfaces were printed as cleanly as possible, hence this orientation.
One of my followers broke, so I needed a replacement, and this model was the solution for my Messerschmitt AR15-9S.
It fits (almost all) Glock pistol and also the 10-round PCC magazines for Schmeisser ARs.
Note: I'm not a professional 3D designer.
I develop or modify models for my own use when there’s no suitable solution available on Makerworld.
Boost Me (for free)
If you like it feel free to Boost it
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)