Thumbgrip Fujifilm X100VI

Practical remix of the excellent thumb grip made by @askelias and available at the following link: https://makerworld.com/it/models/814763-fujifilm-x100v-thumb-grip#profileId-756777

The remix was created with the aim of:

- extending the grip area by 5mm, as I find the original too small and impractical for comfortable thumb rest
- moving the hot shoe mount to a higher position: this ensures that the thumb grip rests not in the void but on the camera body, making the grip more comfortable and functional while simultaneously leaving the buttons free to use

ATTENTION! Printing tips:

• DO NOT CHANGE THE PART'S ORIENTATION! This orientation was specifically chosen to ensure ironing on the top surfaces, in order to achieve a finish similar to that of the camera body. Changing the orientation and removing the inserted support also risks compromising tolerances!
• ADJUST IRONING SETTINGS! Those in the .3mf file work perfectly for calibrations made with my filament and my printer, but they might work very poorly for you! Therefore, perform tests before printing the part to understand which ironing level is best for you
• After printing, FINISHING THE BOTTOM SIDE that rests on the support with sandpaper is NECESSARY! Tolerances are very tight and can change depending on printer calibration, so sanding is ESSENTIAL. Be careful not to damage the top side

After printing, it will be necessary to detach the bottom support. Some force might be needed and the first layer might come off, but since sanding is necessary, this is not a problem

If you like the design, remember to support me with a boost! For any issues, do not hesitate to contact me!