Cheek Riser for Magpul CTR or MOE stock

Follow TinyHatchetBuilder to never miss a preparedness print!

Want a single riser that can do double duty? This Riser for the Magpul MOE or CTR stock lets you put your cheek where it actually needs to be, especially for prone shooting. The reversible design allows you have the riser farther back on the stock to optimize for keeping charging handle capability in stock positions 2-5, or flip it forward if you need extra length for your cheek while shooting prone while keeping charging handle capability in stock positions 4 and 5. 

Current heights available are 0.25, 0.5 and 0.75 inches. Let me know if you need a more specific size and I will add it to the CAD!

This riser fits on snuggly, and removing will typically require a screwdriver to disengage the locking tabs. I left a little space under each tab so that a flathead screwdriver will be able to get underneath to remove the stock while minimizing damage.

The riser will work in any common material, but I recommend PETG at a minimum if this riser will be doing more than guarding your safe so that it will survive high temps in your car or storage and be able to hold up to some bumps. Note that material shrink rates may vary. If you are unable to slip the riser over the stock and engage all the tabs into the stock, you may need to slightly scale up. I have included a test piece so that you can confirm your fit with your material if you wish before printing. All prints were tested with Bambu PETG HF.

All models are designed to print without supports with the “short clip side” on the plate and have been performing well with the following tweaks to standard settings:

Wall loops: 3

Sparse Infill Density: 25%

Sparse Infill Pattern: 3D Honeycomb

I have a whole suite of accessories for the Magpul MOE/CTR as well as the B5 Sopmod and the B5 Bravo.

Here are links to the other items available for the MOE/CTR:

Compact Bag Rider: https://makerworld.com/en/models/2744130-compact-bag-rider-for-magpul-moe-or-ctr-stock#profileId-3043553

Bag Rider with Picatinny: https://makerworld.com/en/models/2860461-bag-rider-with-picatinny-for-magpul-moe-or-ctr#profileId-3192083

Long Bag Rider: https://makerworld.com/en/models/2744912-long-bag-rider-for-magpul-moe-or-ctr-stock#profileId-3044525

Cheek Riser: https://makerworld.com/en/models/2784720-cheek-riser-for-magpul-ctr-or-moe-stock#profileId-3095356

Change Log:

6/8/27: Updated the 0.75 print profile to include the correct riser (previously had the 0.25 riser on accident).

5/10/26: Initial release at Rev A for 0.25, 0.5 and 0.75 models and profiles.