Search models, users, collections, and posts
Intex Graphite Skimmer support
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
5.6 h
2 plates
Open in Bambu Studio
Boost
6
17
0
0
24
17
Released
Description
I mixed two models to achieve this:
https://makerworld.com/en/models/609969-steel-frame-pool-skimmer-mount#profileId-1642860
https://makerworld.com/en/models/440740-intex-graphite-panel-pool-cup-holder#profileId-346426
Resulting in a nice and strong support for the Intex Skimmer.
Using a simple clip without any glue or screws. I recommend printing this in ASA.
Note: ASA filament can be tricky to print. Use a lot of brim, don't hesitate to go up to 25mm and tweak your filament settings. Tested with bambulab's ASA filament.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)