Low Poly Designer Vase – 300mm Tall

Bring a bold and modern statement piece into your home with this extra tall designer vase.
Standing at an impressive 300 mm height, this vase combines elegant curves with a sculptural silhouette to create a futuristic and architectural appearance that looks stunning in any interior setup.

The faceted surface design creates beautiful reflections and shadow details, especially when printed with matte, translucent, or silk filaments. Its smooth transitions and narrow center section give the model a refined and dynamic look from every angle.

This vase was specifically designed to print perfectly on the Bambu Lab H2 Series (or other large printers), making it ideal for high-quality large-format decorative prints.

The model is fully optimized for Vase Mode (Spiralize Outer Contour) using a single wall line, allowing for fast print times while maintaining an elegant lightweight structure.

Features

• Massive 300 mm tall decorative vase
• Modern sculptural and futuristic design
• Optimized for Vase Mode printing
• Single-wall print design
• No supports required
• Perfect for PLA, PETG, or Silk PLA
• Beautiful geometric light reflections
• Stable base design
• Ideal for modern home decor setups

Recommended Print Settings

• Vase Mode / Spiralize Outer Contour: Enabled
• Wall lines: 1
• Infill: 0%
• Layer height: 0.20 mm recommended
• No supports needed
• 0.4 mm nozzle recommended

Compatibility

Designed and tested for the Bambu Lab H2 Series. (H2D in my case)

Important Note

This model is intended for decorative purposes only.
If you want to use it with water or fresh flowers, additional sealing may be required depending on your print settings and material.

Powered by MakerWorld-Make My Vase (https://makerworld.com/makerlab/makeMyVase)