*WORKING* Stylus for iPad, Phone, and touchscreen

A fully working stylus for most touch-screen devices! Works just like a normal one (without pressure sensitivity).

Prints in under 20 minutes!

Includes an optional “ink well” for water.

You can sell this model, as long as you add a link to it

NEEDED:

• Foil (silver foil, or some other similar conductive material)

• A Q-Tip (or cotton)

   

INSTRUCTIONS:

1. Take a piece of foil, and roll it into a circle. Push it into the front of the stylus, making sure it reaches a bit past the hole in the side.

2. Push the Q-Tip (or piece of cotton) into the front hole, making sure it's touching the foil.

3. Push a small piece of foil into the side hole, making sure it touches the foil inside.

4. Make sure the cotton is a bit damp (but not wet).

1. Take a piece of foil, and roll it into a circle. Push it into the front of the stylus, making sure it reaches a bit past the hole in the side.

2. Push the Q-Tip (or piece of cotton) into the front hole, making sure it's touching the foil.

3. Push a small piece of foil into the side hole, making sure it touches the foil inside.

4. Make sure the cotton is a bit damp (but not wet).

Check out my original stylus, which inspired this model:

***

Please help support my mission to make more and more models on MakerWorld stop using restricting licenses. We should all have the right to remix and sell any 3D model for free (with proper attribution).