Print Profile(1)

Description
A luxurious multi-story habitat prepared for the incoming shrimp army
Design Concept
1. Easy to observe, with 360° horizontal viewing
2. There are cutouts (mesh-like grids) between layers, allowing baby shrimp and new fish fry to pass through, and shrimp food to some extent as well
3. Each layer is 1.5cm high, sufficient for black shrimp, fire shrimp, and small fish to hide
4. Each layer has upper and lower elevated stops to hold sinking food (e.g., large shrimp pellets) and floating food (e.g., spinach leaves), preventing them from being easily carried away by water currents
5. The upper edge has light, and the lower part is completely shaded
6. The core has a 1mm chamfer, allowing for potential silicone overflow
7. Total height is 205mm, the A1 mini can print it at a 45° angle
8. Easy to print, almost no supports needed, just a small drop of glue
Boost Me (for free)
2026-05-08: Supports three glass thicknesses: 4mm, 5mm, and 6mm

Installation tip: apply a drop of glue on the positioning pins


Place into the fish tank, hang in the corner

One on each side



License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.










Comment & Rating (0)